Avenview HDM3D-C5SW-R Especificaciones descargar pdf (Pagina 10)

www.avenview.com

1.7.4 SW Main Dip Switch for Firmware Update

DIP Switch Position

PIN # 1

PIN # 2

PIN # 3

PIN # 4

Normal Operation Mode

RS232

OFF 

Normal Operation Mode USB

OFF 

ON 

Firmware

Update

Mode

Block A [main]

ON 

OFF 

Block B [remote]

ON 

OFF 

ON 

OFF 

Block C [HDMI]

ON 

OFF 

6 Factory default for SW Main is pin#1-OFF [



], pin#2-OFF [



], pin#3-OFF [



], & pin#4-OFF [



]. PLEASE

MAINTAIN THIS SETTING AT ANYTIME FOR REGULAR USE VIA RS-232 CONTROL!

7 Sequence for firmware update

WARNING!

[Firmware update only can be done via RS-232 port and connection to PC set at COM1)

[1]. Power off the Matrix unit. Execute the firmware update program on your PC via COM1 port connection

to the RS-232 port of the Matrix unit.

[2]. Set the pin#1 of [SW Main] at ON [



] for firmware update mode.

[3]. Set pin#2 and pin#3 at respective positions to assign which Block to be updated.

[4]. Power on the Matrix unit. The firmware update program should begin this update sequence

automatically. If not, please check the RS-232 connection status between PC and Matrix unit.

[5]. After the OK message shows up to indicate the firmware update sequence for designated Block is

complete, please turn off the Matrix unit.

[6]. Repeat step 3 ~ step6 if you want to update the firmware of the remaining Blocks.

[7]. Set the [SW Main] switch position to Normal Operation Mode.

[8]. Power on the Matrix unit.

[6]. Power on the SW-HDM3D-C5-8X8.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 25 26

Comentarios a estos manuales

Sin comentarios

Avenview HDM3D-C5SW-R Especificaciones Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Ecualizadores de audio Avenview HDM3D-C5SW-R