Avenview RTERM Series Manual de usuario descargar pdf (Pagina 23)

www.avenview.com

Baud Rate

Sets the host port baud rate to 50, 110, 134.5, 200, 300, 600, 1200, 2400, 4800, 7200, 9600,

19200, 38400, 57600, 76800 or 115200.

Rcy Hndshake

Allows the terminal to control the receipt of data from a device connected to the SERIAL1

port with no handshaking (None). Xon / Xoff handshaking. DTR handshaking, DTR / Xoff

handshaking, or by sending special codes (XPC). CPS is possible only when the personality

parameter is set to PC Term.

Data / Stop Bite

Through the SERIAL1 port, the terminal to send and receive 8-bits data with on stop bit or

two stop bits, or 7-bits data with on stop or two stops bits.

Xmt Hndshake

Xmt Hndshake causes the terminal, when sending data to a device connected to the

SERIAL1 port, to ignore all Incoming software hand-shaking singles (None) or to control

data output in respons to Xon/Xoff handshaking.

Partly

Cuases the terminal send the data to the SERIAL1 port with none, odd, mark, even, or space

partly.

Comm Mode

Sets the SERIAL1 port communication mode to full duplex (FDX), block (BLK), half duplex

(HDX), or half-duplex block (HBLK)

Printer Selection:



Parallel: Sends data to a parallel printer connected to the parallel port



Serial: Send data to a serial printer connected to the SERIAL2 port



Off: Ignores the printer command

Ethernet Mode

On / Off to set the communication routing by Ethernet Network or Serial Port.

Multiple

Sessions

Defines Ether terminal have multiple sessions function:

ON: Indicates the terminal has multiple sessions function, but each session only has one

page display. In 80 or 132 column mode, 4 session simultaneously. In Econ-80 colum mode

7 sessions simultaneously.

OFF: Indicates the terminal only has single session, but it has multiple pages display.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 74 75

Sin comentarios

Avenview RTERM Series Manual de usuario Pagina 23