Avenview HDM-C6VWIP-SET Especificaciones descargar pdf (Pagina 19)

Command vw2 add vw-name rx1 position rx2 position

Return videowall2 item vw-name(n*m) configuration added:

rx1 position1

rx2 position2

...

Note Configure the video wall vw-name and add the corresponding TX and RX.

E.g.: “vw2 add wall1 Screen1 1 1 Screen2 1 2 Screen3 2 1 Screen4 2 2” Sets the RX units with alias’

Screen 1 to 4, to the noted x y positions in the video wall. Note a video wall by the name of wall1 must

have already been created using “vw2 add wall1 2 2 tx1 tx2” before this command can be used.

Command vw2 add vw-name layout n m TX1 RX11 RX12 … RXnm TX2 RX21 RX22 ... RXnm

Return videowall2 vw-name layout n*m tx1 rx11 rx12 … rxnm rx1 tx2 rx21 ... rxnm

Note Add a video wall layout n*m, subsequently the RX based on display order. The Parameter Rx could be char-

acter ‘0’, indicates no need to change the corresponding RX.

E.g.: “vw2 add wall1 layout 2 2 Source1 Screen1 Screen2 Source2 Screen3 Screen4” Creates a 2x2 video wall

using RX1 for row one and TX2 for row 2.

Command vw2 add vw-name n m tx1 tx2 ... txn

Return videowall2 item vw-name(n*m) create and assign tx1 tx2 ... txn to it

Note Create a video wall configuration, and assign a TX for each row.

E.g.: “vw add wall1 2 2 Source1 Source2” Creates a 2x2 video wall using RX 1 for row one and TX2 for

row 2.

Video-Wall 2

The vw2 is a special command set used for multi-host mode if the tearing delay command fails to resolve the tearing on a

video wall.

Command vw2 rm vw-name

Return videowall2 item vw-name removed

Note Remove a video wall configuration

E.g.: “vw2 rm wall1” removes wall1 configuration from the

Command vw2 rm vw-name rx1 rx2 rx3

Return videowall2 config change:remove rx1 rx2 rx3 hostname from vw-name

Note Remove one or multiple rx from video wall.

E.g.: “vw2 rm wall1 Screen1” removes Screen1 from the video wall

Command vw2 change vw-name tx1 tx2 tx3 txn

Return videowall2 vw-name config change:

row1 tx1

row2 tx2

Note Change the selected input or inputs of a video wall, replacing a tx alias with 0 means no change.

E.g.: “vw2 change wall1 Source1 0 Source3” Changes Wall1 inputs for row1 & row3 to rx1 & rx3

Command vw2 reset tx

Return videowall2 reset tx

Note Remove the video wall configuration of this tx and display a complete picture. (If this tx is in video wall mode, it

will only display part of the picture.)

www.avenview.com

Page 17

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25

Sin comentarios

Avenview HDM-C6VWIP-SET Especificaciones Pagina 19