Avenview W-HDM3D-100-SET Guia de preparacion descargar pdf (Pagina 5)

www.avenview.com

Page 3

4. PLAN THE INSTALLATION

• Identify the signal source to wireless transmit (example A).

• Determine the location of the W-HDM3D-S-100 transmitter (Tx) unit (example B).

• Find a suitable power source for the transmitter.

• Identify the destination to receive the wireless signal (example C).

• Determine the location of the W-HDM3D-R-100 receiver (Rx) unit (example D).

• Find a suitable power source for the receiver.

The transmitter and receiver units can stand alone on a flat surface, or use various brackets to mount onto other objects

such as a display monitor. It is recommended to verify that the wireless system is operating properly before mounting the

Tx or Rx units permanently. See the W-HDM3D-S-100 user guide for complete mounting instructions.

For best installation results:

• The Tx and Rx should face each other.

• The Tx and Rx should be no more than 10 meters (33 ft.) apart.

• The Tx and Rx should be between 1.8-3 meters (6-10 ft.) above the floor.

• The Tx and Rx should not be in a confined location.

1 2 3 4 5 6 7 8 9 10

Sin comentarios

Avenview W-HDM3D-100-SET Guia de preparacion Pagina 5